Why am I getting snipe on my jointer?

Why am I getting snipe on my jointer?

Jointer snipe occurs when the outfeed table is positioned below the jointer knives. In most jointers the height of the outfeed table is adjustable, and that makes the fix to jointer snipe a relatively easy one. Ensure that the knives are set properly.

What adjustments can you make on the jointer?

A jointer requires fewer adjustments than a tablesaw—just three or four, depending on the design of your machine….Tuning up your jointer

• 1 Check the tables for parallel alignment.
• 2 Square the fence for square cuts.
• 3 Set the knives.
• 4 Adjust the outfeed table.
• 5 Test your adjustments.

How high should jointer blades be?

On these machines, set the height of the knives about 0.003 inch above the height of the outfeed table. Planer knives are set parallel to the head, that is, each knife projects the same amount.

What is the advantage of a parallelogram jointer?

Another benefit of a parallelogram jointer over a dovetail style is the ease of making table height adjustments. The cam and arc design of the parallelogram allow the user to simply raise and lower a table with a lever.

What is planer snipe?

Some planers (sometimes jointers and drum sanders too) have a really annoying habit of digging in deeper at the beginning and/or ends of boards. This phenomenon is called snipe. Snipe occurs when the board lifts slightly, due to the fact that it is only being held down by this single roller.

Why is my jointer not cutting straight?

In some cases, this can be caused by infeed and outfeed tables that aren’t parallel. But a more common (and easier to fix) cause is an outfeed table that is just a bit higher than the jointer knives.

What should you not do with a jointer?

Never make adjustments when the jointer is running. Don’t try “freehand” manipulations that do not require use of the fence. Avoid heavy cuts that might jam the cutterhead. Take off no more than 1⁄ 16 ” per pass on softwoods and even less on hardwood stock.

How does the jointer PAL wood Whisperer work?

Like the Jointer Pal, this system works using magnets, only this one bridges the infeed and outfeed tables. It also has a nice dial that you turn to raise and lower the center magnet, which allows you to micro-adjust the blade.

What does an elevation wheel on a jointer do?

In place of the hand planeʼs sole, jointers have a pair of tables that support the stock as you pass it over a rapidly turning cutterhead. Down below, an elevation wheel provides a means for adjusting the height of the infeed table, and many jointers have a control for the outfeed table as well.

Which is the best jig for jointer setup?

If you want cheap and simple with somewhat unpredictable results, go for the Jointer Pal. If you want a jack of all trades setup jig, go for the A-Line-It. And if you want the best jig for the job, get the ONEWAY.

How long does it take to set up a jointer?

Its perfect for folks who don’t want to fuss around with dial indicators since the magnet does all the work. And it is fast and easy to use (about 3 minutes per blade). But since jointer blades tend to raise up when you tighten them in place, you have no way of knowing if your blades truly are level with the outfeed table.