What is in the engine room of a ship?

What is in the engine room of a ship?

On a ship, the engine room (ER) is the compartment where the machinery for marine propulsion is located. It houses the vessel’s prime mover, usually some variations of a heat engine (diesel engine, gas or steam turbine).

What does an engine man do in the Navy?

Navy Enginemen (EN) control the operation of diesel engines used for ship propulsion, electrical power generation and other services. Additional job responsibilities as an EN may include: Aligning oil, water and air piping systems. Operating diesel generators used to produce electrical power.

What is engine room arrangement?

The accommodation block is usually arranged above the engine room and both of them must be very well coordinated to create one logical solution. Detailed Engine Room Arrangement with the Index of Machinery and Equipment shall be the part of the Contract Design.

What engine is in a Navy destroyer?

Each DDG ship is powered by four LM2500 gas turbines which are in a combined gas and gas (COGAG) configuration. Each reduction gear combines the input of two LM2500 engines rated at 26,250 brake horsepower (bhp) for a total output of 105,000 bhp per ship.

Why does engine room should always be under positive pressure?

Engine room should always be under positive pressure to assist ME and Generators turbocharging. Also, necessary to maintain ship’s engine room temperature. To avoid any hazard when engine room is unattended, make sure all combustible materials are stored in a safe place and secured properly.

What is ENFA in Navy?

Enginemen operate, service and repair internal combustion engines used to power some of the Navy’s ships and most of the Navy’s small craft.

What procedure you will follow while taking over engine room watch?

After Entering the Engine Room Check for notice left by the previous duty engineer of the watch on notice board, if any. Take proper round of the engine room checking of any leakages and machinery parameters. Keep on resetting the dead man alarm before its preset time. Once all is OK, inform C/E.

Where is the boiler room on the USS Kitty Hawk?

And then you run out of time, and miraculously, you are ready. After lighting the boiler, gauges are monitored by a Boilerman Technician in the No. 4 main machinery room aboard the aircraft carrier USS KITTY HAWK

Who is the watch supervisor in the forward engine room?

The watch supervisor in the Forward Engine Room (Main Control) was normally a Chief or First Class Petty Officer of the Machinist’s Mate (MM) rating who served as the Engineering Officer of the Watch (EOOW). The EOOW was responsible for overall coordination of the engineering plant, including all communications with the bridge.

Who is the Chief Engineer of the Navy?

They finally announce that they are ready to submit their report, first in private to the Commanding Officer (CO) and Chief Engineer (CHENG), and then to the world, all gathered in the wardroom. No one smiles. The senior member reads an almost endless list of discrepancies.

How does steam testing work in the Navy?

But the tempo is increasing, and steam testing is beginning. That means real steaming, but with different yard shops demanding your attention to support their protocols. Things get more and more hectic and the hours get longer the closer you get to the end of the overhaul.