How do you test a fire hose?
How do you test a fire hose?
With the test cap open, the pressure shall be raised gradually to 45 +/- 5 psi allowing all air to be removed from the system. Close the test cap slowly as well as the outlet water supply valve. Secure the hose directly behind the test cap to avoid whipping or other uncontrolled reacting in the event of a hose burst.
What is fire hose testing?
Identification number assigned using a barcode on each coupling and redundant marking on the hose jacket. Inspect outer jacket, inner liner, couplings and threads. Inspect gaskets and replace as required. Lubrication of couplings using fire hose manufacturer approved 100% silicone lubricant.
What pressure is fire hose tested at?
200 psi
Supply fire hose shall be service tested to a minimum of 200 psi (13.8 bar or 1380 kPa) or a pressure not to exceed the service test pressure marked on the hose.
When should fire hose be replaced?
Even though a section of 15- year old fire hose may still pass an annual test, the fire chief should consider a 10-year maximum service life under normal operating conditions. Section 512C of the ISO FSRS addresses the testing of fire hose. For maximum points, the fire department must test all fire hose annually.
Does fire hose expire?
Fire hose does not last forever, and a good fire administrator should plan for its eventual replacement through a program that predicts replacement years, estimated costs, and identifies the funding source for the replacement hose.
How much pressure is needed to test a fire hose?
Supply fire hose shall be service tested to a minimum of 200 psi (13.8 bar or 1380 kPa) or a pressure not to exceed the service test pressure marked on the hose.
How long does fire hose last?
Taking good care of your fire hoses can go a long way in increasing the years you get out of each hose. Taking care of a fire hose the “prescribed” way can lead to a useful life of 10–20 years.
What pressure do you test fire hose at?
What is the NFPA standard on fire hose?
Standard on Fire Hose. This standard defines the design and construction requirements for new fire hose, the testing required to verify the design and construction, and the inspection and testing required of all new fire hose. Please note: This Standard is no longer accepting Public Input due to the Emergency Response and Responder Safety Document Consolidation Plan ( consolidation plan) as approved by the NFPA Standards Council.
Do fire hoses have to be inspected?
As with any element of fire protection, your building’s fire hose needs to be inspected and certified with your local agency. But regardless of agency requirements, you want to be sure your hoses are working so you can protect your building.
How long is fire departments fire hose?
The standard length is 10 ft (3.05 m). Another suction hose, called a soft-suction hose, is actually a short length of fabric-covered, flexible discharge hose used to connect the fire pumper suction inlet with a pressurized hydrant. It is not a true suction hose, since it cannot withstand negative pressure.
Fire hose testing includes: Removal of fire hose from apparatus or storage. Labeling and recording of all information for each length of hose. Inspection of all fire hose, nozzles, couplings and appliances in accordance with NFPA standards.